Comprehensive CVG-VP4xl - Manual (Page 7)

3
5 Connecting Your CVG-VP4xl 1:4 VGA Distributor
To connect the CVG-VP4xl 1:4 VGA Distributor to up to 4 outputs, do the
following
1
:
1. Connect an XGA source (for example, a PC’s digital graphics card) to the
INPUT HD15F connector.
2. Connect the OUTPUT HD15F connectors to up to 4 XGA acceptors
2
, as
follows:
• Connect the OUTPUT 1 connector to Acceptor 1 (for example, an analog
monitor)
• Connect the OUTPUT 2 connector to Acceptor 2 (for example, a
projector)
• Connect the OUTPUT 3 connector to Acceptor 3 (for example, an analog
monitor)
• Connect the OUTPUT 4 connector to Acceptor 4 (for example, a
projector)
3. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
Figure 2: Connecting the CVG-VP4xl 1:4 VGA Distributor
1 Switch OFF the power on each device before connecting it to your CVG-VP4xl. After connecting your CVG-VP4xl, switch
on its power and then switch on the power on each device
2 When only one output is required, use one of the outputs, and leave the other outputs unconnected