Comprehensive CVG-VP3xl User Manual
Page 6
4
5 Connecting Your CVG-VP3xl 1:3 VGA/UXGA Distributor
To connect the
CVG-VP3xl in order to output the XGA signal from a laptop’s
graphics card to up to 3 monitors (as the example in Figure 3 illustrates), do the
following
1
:
1. Connect an XGA source (for example, a laptop’s digital graphics card) to
the INPUT HD15F connector.
2. Connect the OUTPUT HD15F connectors to up to 3 acceptors
2
, as follows:
Connect the OUTPUT 1 connector to an acceptor (for example, Monitor 1)
Connect the OUTPUT 2 connector to an acceptor (for example, Monitor 2)
Connect the OUTPUT 3 connector to an acceptor (for example, Monitor 3)
3. On the underside of the
CVG-VP3xl:
Slide the PIN 11 ID BIT CONTROL switch to the left to set to ON
Slide the PIN 4 ID BIT CONTROL switch to the left to set to ON
4. Connect the power cord
3
(not illustrated in Figure 3).
Figure 3: Connecting the CVG-VP3xl 1:3 VGA/UXGA Distributor
1 Switch OFF the power on each device before connecting it to your CVG-VP3xl. After connecting your CVG-VP3xl, switch
on its power and then switch on the power on each device
2 When only one output is required, use one of the outputs, and leave the other outputs unconnected
3 We recommend that you use only the power cord that is supplied with this machine