Comprehensive CVG-VP6XL - Manual (Page 5)

3
5 Connecting Your CVG-VP6xl 1:6 VGA Distributor
To connect the CVG-VP6xl 1:6 VGA Distributor to up to 6 outputs, do the
following 1 :
1. Connect an XGA source (for example, a PC’s digital graphics card) to the
INPUT HD15F connector.
2. Connect the OUTPUT HD15F connectors to up to 6 XGA acceptors
2
, as
follows:
Connect the OUTPUT 1 connector to Acceptor 1 (for example, an analog
monitor)
Connect the OUTPUT 2 connector to Acceptor 2 (for example, a
projector)
Connect the OUTPUT 3 connector to Acceptor 3 (for example, an analog
monitor)
Connect the OUTPUT 4 connector to Acceptor 4 (for example, a
projector)
Connect the OUTPUT 5 connector to Acceptor 5 (for example, an analog
monitor)
Connect the OUTPUT 6 connector to Acceptor 6 (for example, an analog
monitor)
3. Connect power cord (not illustrated in Figure 2).
Figure 2: Connecting the CVG-VP6xl 1:6 VGA Distributor
1 Switch OFF the power on each device before connecting it to your CVG-VP6xl. After connecting your CVG-VP6xl, switch
on its power and then switch on the power on each device
2 When only one output is required, use one of the outputs, and leave the other outputs unconnected