Continental Industrie Model - 400 - Manual (Page 2)

Values, dimensions and reference in this brochure are approximate and intended as guide only, not for construction and are subject to change without notice
DETAILED ENGINEERING DESCRIPTION - CONTINENTAL INDUSTRIE
DEB400EN – 04/2010
2/4
4.0 Bearing housing
The outboard bearing housings are cast iron and bolted to the outside of the head sections
insuring cool operation of bearings.
4.1 Cast iron EN-GJL-250 (ASTM A48-35B).
4.2 Two cored openings are provided to allow circulation of air (except for gas). 4.3 Has
cast fins to improve rigidity and increase heat dissipation
4.3 Labyrinth type oil seal. Oil passages are generously sized to allow optimum
recirculation.
4.4 Has air vent and magnetic plug at the bottom of the oil reservoir.
4.5 Provided with 4 tapped holes in the housing flange to act as bearing puller.
N.B.: When the inlet air or gas temperature is too high, we can adapt as option special
bearing housings with a water or air cooling system (technical drawing on request).
5.0 Bearings
5.1 The rotor assembly is supported by 2 heavy duty oil lubricated ball bearings, single
row, sized to withstand the thrust load also type SKF or FAG.
5.2 Sized for minimum 10 years of operation (Direct Drive only), following SKF L10
bearing life calculation method.
5.3 Bearings are mounted in outboard type bearing housings and located so that
bearings may be serviced without disassembling the blower casing or piping.
6.0 Shaft
6.1 42CrMo4 (AISI 4140) carbon steel shaft, heat treated, straightened and stress-
releved
6.2 Shaft is ground all over
6.3 Stiff shaft design to minimize vibration
6.4 The diameter of the shaft end is 65 mm (2.56”)
7.0 Shaft seals
7.1 Shaft sealing is accomplished using graphite ring seals or carbon ring seals.
8.0 Impellers
8.1 The impellers are fabricated in aluminium shrouds, fixed on a rigid hub in cast
aluminium.
8.2 For minimum corrosion all aluminium alloys are non copper alloys
8.3 The outer diameter of the impeller is 662 mm (26”)
8.4 Each impeller is statically balanced.
8.5 Impeller tip speed: 122 m/sec (400 FPS) at 3600 rpm.
8.6 First critical speed (7 stages) 4505 rpm.
8.7 Impeller assembly: to consist of a heavy steel shaft accurently machined and one or
more fabricated aluminium impeller(s), statically balanced, securely keyed to shaft
and held in place by lock washers and locknuts.