CTEK XS 0.8 - Manual

EN
EN • 3
12V/0.8A
XS 0.8
ERROR LAMP
fuLLy chARgEd REAdy tO usE
POWER LAMP
chARgiNg
1. Connect the charger to the battery.
2. Connect the charger to the wall socket. The power lamp will indicate that the mains
cable is connected to the wall socket. The error lamp will indicate if the battery clamps
are incorrectly connected. The reverse polarity protection will ensure that the battery
or charger will not be damaged.
3. Follow the 6-step display through the charging process.
The battery is ready to start the engine when STEP 3 is lit.
The battery is fully charged when STEP 5 is lit.
4. Stop charging at any time by disconnecting the mains cable from the wall socket.
cONgRAtuLAtiONs
to the purchase of your new professional switch mode battery charger. This charger is
included in a series of professional chargers from CTEK SWEDEN AB and represents the
latest technology in battery charging.
ctEK cOMfORt cONNEct – eyelet M6
12V/0.8A
XS 0.8
ctEK cOMfORt cONNEct
MAiNs cABLE
ctEK cOMfORt cONNEct – clamp
chARgE cABLE
suPPLy PLug*
*supply plugs may differ to suit your wall socket.
MANuAL
20014896E XS 0.8, Manual EU, Print file 003.indd 3 2011-10-10 16:25:43