CTI Products TurboVUi Solo Client Software - Manual (Page 10)

TurboVUi Solo User Guide
10
M ENUS
FILE menu
Disconnect
This menu item allows a user to disconnect the current user from the TurboVUi IP Gateway
module. The “Connect to TurboVUi Gateway” login window is then displayed.
Exit
This menu item will close the Client program.
RADIO Menu
This menu provides direct remote control of certain radio functions.
Permanent Monitor
Selecting Permanent Monitor will allow the receiver to pass all traffic received on the
selected channel.
Scan
Disables or enables the radio scanning for voice activity by cycling through the
channel/group sequence specified in the scan list for the current channel/group.
Power
This allows the quick selection between High or Low Transmit Output Power levels of the Radio.
Emergency TX
If enabled in the radio code plug this feature sends out a distress signal from the Control Station that triggers an audible
alert in the RF field unit of every active user.
CHANNEL Menu
Zone #:
This menu item will choose a zone that has been previously defined. Each zone will consist of up to
16 channels that have been previously defined on the MOTOTRBO Radio.
VIEW Menu
Active Users
This menu item will display a list of
connected client users. Each user will be displayed with their Username and IP Address.
Text Messaging & Quick Text
This menu item will allow the user to select a Recipient from the Send To: drop down menu,
and after typing the desired text the send button will send the message to the desired receiver.
Also the quick text message feature will allow the user to select a preconfigured text message
to send to the Recipient. The quick texts can be defined in the settings menu, see Quick Text
under the Settings Menu section on Page
10 for more information.
Note: Text Messaging will function only with radios in Digital mode.