Controlled Products Systems Group 1504-080 - Manual (Page 16)

2.4 Programming Four-digit Entry Codes
1. Press *02 and enter the four-digit master code _ _ _ _ (short beep).
2. Enter the four-digit code _ _ _ _ then press * (beep).
3. Repeat step 2 to enter additional entry codes. Note: the number of codes that can be
entered is dependant on the memory size ordered.
4. Press 0# together to end the programming step (long beep).
2.5 Erasing Individual Four-digit Entry Codes
1. Press *08 and enter the four-digit master code _ _ _ _ (short beep).
2. Enter the four-digit code to be erased _ _ _ _ then press * (beep).
3. Repeat step 2 to erase additional entry codes.
4. Press 0# together to end the programming step (long beep).
2.6 Erasing ALL Four-digit Entry Codes
CAUTION: This sequence will erase ALL four-digit entry codes that have been previously
programmed into the keypad and is irreversible.
1. Press *00 and enter the four-digit master code _ _ _ _ (short beep).
2. Press 9 9 9 9 * (short beep).
3. After approximately 10-seconds, a long beep will be heard indicating that all four-digit
entry codes have been erased.
2.7 Four-digit Entry Code Divide Number
The four-digit entry codes can be made to activate either relay 1 or relay 2 by programming a four-
digit "divide" number. Four-digit entry codes equal to or less than the divide number will activate relay
1, while four-digit entry codes greater than the divide number will activate relay 2. If no divide number
is programmed (enter # # # # in step 2), then relay 2 acts as an alarm by-pass relay, activating .1
second prior to relay 1, and deactivating .1 second after relay 1.
Important: Both four-digit and five-digit entry codes must be programmed to operate in the same
mode. If a divide number is programmed for the four-digit codes, then a divide number must also be
programmed for the five-digit entry codes (see page 17). The system is preset at the factory with no
divide numbers programmed.
1. Press *12 and enter the four-digit master code _ _ _ _ (short beep).
2. Enter a four-digit divide number _ _ _ _ then press * (short beep).
3. Press 0# together to end the programming step (long beep).
Note: To delete the four-digit entry code divide number, enter # # # # in step 2. This will cause relay 2
to act as an alarm by-pass relay provided that the five-digit divide number has also been deleted (see
page 17).
Page 16 1506-065-D-1-09