Controlled Products Systems Group 222EX43 - Manual (Page 30)

13 © 2012 Installation and Reference Manual D0119 Rev. J
Section 2
— Installation
11
. Check the operator “Hand”
All slide operators must have their “handing” set
before they can function. The “handing” must be
set both by the proper hydraulic hose connection
and by programming the Smart Touch
Controller. The proper handing hose connection
is described on a label near the hose connection
point. Also, see the instructions to set handing
on page 19. Operators are shipped configured
for right hand operation. Handing is viewed by
standing on the secure side looking out. A gate
which opens to the right is a right-handed gate.
12. Replace the Shipping Plug!
Replace the red plastic shipping plug on the
front side of the pump with the black breather
cap.
13. Setup the Smart Touch Controller
The operator controls will not allow the gate to
function until the Smart Touch Controller has
been configured.
Wait to connect external controls until you have reviewed Smart
Touch Controller instructions and tested operator basic functions.
“Right Hand” shown
Remove red plastic
shipping plug and
replace with black
breather cap.
To change handing
connect hoses
according to label on
tank.