Alamo Eagle 20 - Manual (Page 171)

MAINTENANCE
Eagle 20 03/09 Maintenance Section 5-21
© 2009 Alamo Group Inc.
MAINTENANCE
Disassembly of Divider Gearbox
(Trained dealer personnel only)
STEP 1
Remove all eight of the M10 Bolts from both Cap Hubs, using a 14mm socket. FIGURE Mnt-R-0048. Remove
the Hub Assemblies and gaskets from the Main Housing. FIGURE Mnt-R-0048.
STEP 2
Remove the Hub Assembly from the vise and place it on a solid surface with the Gear in an upright position.
Using a Hammer, tap this Gear downward until the Adjusting Nuts fully exposed. Remove the Cotter Pin.
Remove the Adjusting Nut. FIGURE Mnt-R-0049.