Controlled Products Systems Group NT-T5-ETLDUAL - Manual (Page 3)

3 3
WARNING
- To reduce the risk of injury or death:
 READ AND FOLLOW ALL INSTRUCTIONS.
 Installation should be performed by a professional installer.
 Should electricity be required, use a certified electrician only.
 Any device that requires 120 Volts AC should be U.L. approved.
 Install control devices such as keypads far enough away (5 feet or further) from any
moving parts of the operator and gate to prevent possible injury.
 A secondary entrapment device such as loop detectors, edge switches, and beam
detectors are highly recommended and required to meet the UL325 standard.
 Review with the owner all safety concerns including:
 Do not operate the gate unless area around gate is in full view.
 Never let children operate or play with operator controls. Keep the remote con-
trol away from children.
 Always keep people and objects away from the gate. NO ONE SHOULD CROSS
THE PATH OF THE MOVING GATE/ARM.
 Test the operator monthly (see STEP 7 Programming the current sensitivity).
 The gate MUST reverse on contact with a rigid object or stop when an object
activates the non-contact sensors. After adjusting the force or limit of travel, re-
test the operator. Failure to adjust and retest the gate operator properly can in-
crease the risk of injury or death.
 Arrange with local fire and law enforcement for emergency access.
 Always disconnect the battery or power source when making adjustments or
repairs to any part of the operator.
 The entrance is for vehicles only. Pedestrians must use separate entrance.
 Auto Close feature not recommended without a safety device such as a loop
detector or photo eye.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS