Controlled Products Systems Group SPX-7200 - Manual (Page 10)

3. Select the device to be configured with a mouse click. The device will highlight in
blue as shown above when selected. Verify which device is to be configured by the
MAC address. The MAC address is printed on the Xport module. i.e. make sure you
are configuring the correct Central unit or Remote unit.
4. Click on the “Select IP” button. The dialog box shown above will open. Enter an
IP address for the unit. The IP address should be unique and on the same subnet as
the host computer. Click on the “OK” button after the IP address has been entered.
There will be a delay while the unit reboots. After reboot the unit should reappear in
the device list.
Note: If the unit does not appear in the device list, check power and network
connections. You will not be able to proceed if you are unable to see the unit to be
configured in the device list.
Device in
List
Setting IP Address - SPX-7200