Controlled Products Systems Group MINI-T - Manual

NOTE: If the transmitter fails to activate
the receiver, first check the coding
switches in the receiver to make sure that
the receiver’s digital code system
matches that of the miniTransmitter. Next
check the battery and replace it if it is
weak. Although the battery should last for
two years with normal use, it is good
practice to install a new battery every
year. A slowly flashing or steadily lit LED
on the transmitter indicates that the
battery is too low for transmission to
occur. A rapidly flickering light during
transmission indicates that the unit is
operating properly.
FCC ID: EF4 793 DNT00026
This device complies with FCC Rules Part 15. Operation is subject
to the following two conditions: (1) This device may not cause
harmful interference and (2) This device must accept any
interference received, including interference that may cause
undesired operation.
LIMITED WARRANTY
This product is warranted to the consumer against defects in
material and workmanship for one year from the date of purchase.
This warranty applies to first retail buyers of new devices. Warrantor
will repair, or at its option, replace, any device it finds that requires
service under this warranty, and will return the repaired or replaced
device to the consumer at the warrantor’s cost. For warranty service
and shipping instructions contact warrantor at the address shown
below. Devices must be sent to warrantor for service at owner’s
expense. The remedies provided by this warranty are exclusive.
Implied warranties under state law are to the one year period of this
written warranty. Some states do not allow limitations on how long
an implied warranty lasts, so the above limitation may not apply to
you. In order to be protected by this warranty, save your proof of
purchase and send copy with equipment should repair be required.
This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
All products returned for warranty service require a Return
Product Authorization Number (RPA#). Contact Linear Technical
Services at 1-800-421-1587 for an RPA# and other important
details.
IMPORTANT !!!
Linear radio controls provide a reliable communications link and fill
an important need in portable wireless signaling. However, there are
some limitations which must be observed.
* For U.S. installations only: The radios are required to comply
with FCC Rules and Regulations as Part 15 devices. As such,
they have limited transmitter power and therefore limited
range.
* A receiver cannot respond to more than one transmitted signal
at a time and may be blocked by radio signals that occur on or
near their operating frequencies, regardless of code settings.
* Changes or modifications to the device may void FCC compli-
ance.
* Infrequently used radio links should be tested regularly to
protect against undetected interference or fault.
* A general knowledge of radio and its vagaries should be gained
prior to acting as a wholesale distributor or dealer, and these
facts should be communicated to the ultimate users.
Copyright © 1999 Linear Corporation 106914 D
Delta-3 Series
miniTransmitter
Digital Transmitter
Code Setting Instructions
(800) 421-1587
•
www.linearcorp.com
INSTR,CODE SET,MINI XMTR
Linear P/N: 106914 D
Material: 20 Lb.Mead Bond
Ink: Black
Side 1 of 2
Scale: 1-1
8.500"
5.500
"