Controlled Products Systems Group SK-919TDWS-BU - Manual (Page 2)

Battery
Battery Operated 12VDC Output
Adapter
Power on
Transmission
Push-Button
or contact
12VDC Alkaline
battery included
12VDC
adapter is optional
Example Connection Diagrams:
12VDC
Adapter
INSTALLATION:
1) Power Connection – The wired transmitter can be
powered by the factory preinstalled 12VDC alkaline
battery or by an external 12VDC regulated adapter
(not included).
If an external power adapter is preferred, connect the
red & black wires of the wired transmitter to the
adapter’s output wires. Correct wire polarity must
be observed. Red wire is for positive and black wire
is for negative.
NOTE: a) The power input range of the wired
transmitter unit is 9~13.8VDC.
Connecting more than 13.8VDC power or
reversing the polarity will burn out the unit
and void the warranty.
b) Use only 12VDC “regulated” adapters
to power the wired transmitter.
c) There is a factory-preinstalled 12VDC alkaline
battery inside the wired transmitter unit. If it
is necessary to connect an external adapter,
first remove the internal alkaline battery.
Otherwise the internal battery will become
defective and may overheat, leak, or explode.
2.) External Switch Connection – Aside from its own
built-in single button, the wired transmitter can also
be controlled by an external N.O. pushbutton / sensor
switch (not included), or use both the built-in &
external switches (see Example Connection Diagram
below). If an additional external N.O. switch is
necessary, connect the two blue wires to the switch
terminal.
NOTE: If the red & black or the two blue wire pairs are
not being used, the tips of the wires (where the
copper is exposed) must be cut or wrapped to
avoid a short circuit.
WARRANTY:
ENFORCER Wired Single-Channel RF Transmitters are warranted against
defects in material and workmanship while used in normal service for a period of one (1) year
from the date of sale to the original customer. Our obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation pre-paid, to SECO-LARM.
NOTICE
The information and specifications printed in this manual are current at the time of publication.
However, the SECO-LARM policy is one of continual development and improvement. For this
reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also
not responsible for misprints or typographical errors.
Copyright © 2006 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be
reproduced or copied, in whole or in part, without the written permission of SECO-LARM.
SECO-LARM SECO-LARM SECO-LARM SECO-LARM SECO-LARM ® U.S.A., Inc. U.S.A., Inc. U.S.A., Inc. U.S.A., Inc. U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
Website: www.seco-larm.com
E-mail: [email protected]
PITSW1
Order Part # 762-103/934
MiSK-919TDWS-Bb.pmd