Controlled Products Systems Group 1802-082 User Manual
Page 31
3.3 Programming
Messages
and Names (1802-EPD only)
These programming steps in Section 3.3 apply only to the 1802-EPD system. The keypad on the
1802-EPD has all the letters of the alphabet, the numbers 0 through 9, and a space key printed on it.
This allows the keypad to be used to program all names and numbers into the systems electronic
directory.
NOTE: Messages or names can only be programmed from the system keypad. You cannot program
messages or names from a remote location using a touch-tone telephone.
3.3.1
Programming Letters and Numbers
When entering names into the electronic directory using the system keypad, pressing the key once
will display the first letter listed on the button, pressing twice will display the second letter, pressing it
a third time will display the third letter, and pressing it a fourth time will display the number (or fourth
letter).
Example using the number 6 key:
MNO
6
Press one time to display the letter M
Press two times to display the letter N
Press three times to display the letter O
Press four times to display the number 6
The chart below provides the sequence required to enter each letter and number from the keypad into
the system memory. A sequence is also provided to add a space, clear the display if a mistake is
made, and a sequence to skip a name if there is a desire not to provide a name with a phone number.
To Display
Press
To Display
Press
To Display
Press
A 2*
N 66*
0 0*
B 22*
O 666*
1 11*
C 222*
P 7*
2 2222*
D 3*
Q 77*
3 3333*
E 33*
R 777*
4 4444*
F 333*
S 7777*
5 5555*
G 4*
T 8*
6 6666*
H 44*
U 88*
7 77777*
I 444*
V 888*
8 8888*
J 5*
W 9*
9 99999*
K 55*
X 99*
SPACE
1*
L 555*
Y 999*
CLEAR
#
M 6*
Z 9999*
SKIP
LINE
*
1802-065-C-1-08
Page
31