DoorKing 1838 Multi-Door Access Controller - Manual (Page 34)

3.4.5 Delete Phone Number
This programming sequence is used to delete the phone number under a known directory code.
1. Press * 0 1 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3. Press # # # # # # # then press * (beep).
4. Press 0 # TOGETHER to end this programming step (beeeeeep).
3.4.6 Delete Area Code
This program sequence deletes the area code programmed into the system.
1. Press * 2 4 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 1 then press * (beep).
3. Enter # # # # then press * (beep).
4. Press 0 # TOGETHER to end this programming step (beeeeeep).
3.4.7 PBX Line Access Code Programming
If the 1838 / Remote Call Station system is connected to a PBX telephone system rather than a
dedicated C.O. line, you may need to set the unit to dial a line access code prior to dialing the a
phone number. Typically, the line access code is “9”, but check with the PBX system administrator to
be sure.
1. Press * 0 9 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the line access code number _ then press * (beep).
3. Press 0 # TOGETHER to end this programming step (beeeeeep).
NOTE: To change a line access number, enter the correct number in step 2. To
delete a line access number, enter # in step 2.
3.4.8 Touch Tone Dialing Pause
During touch-tone dialing, the system (by default) places a 2 second pause after dialing a line access
code (9 in a PBX system for example) and after the area code. For example:
9 (2 second pause) 1310 (2 second pause) 6450023
The 2 second pause can be removed by programming 0 into the steps below. In this example, the
system would simply dial out the line access code (9), area code (1310) and phone number
(6450023) without any pauses.
913106450023
Factory setting is 1 (pause ON).
1. Press *27 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 0 * (beep) to turn the pause OFF, or enter 1 * to turn the pause ON..
3. Press 0# TOGETHER to end this programming step (beeeeeep).
Page 34 1838-065-U-4-13