Controlled Products Systems Group 212ILMBZ - Manual (Page 11)

6051344 Rev. 1.0 Page 11 of 17
Step 7: Doorbell Option:
When the doorbell feature is enabled there will be visual and audio keypress feedback for the bell button
but when the feature is disabled there will be no keypress feedback. This doorbell feature has two modes
of operation: timed and continuous. Timed will allow programming of the output for a specified number of
seconds with a single short press. The doorbell is set for continuous by default and output bell sounds for
as long as the button is pressed.
Enabling or disabling Doorbell Option:
Enter Programming Mode: 99# (Master code)
*
Next press Command number 30 followed by the # key.
Next press "5" for the doorbell option followed by the # key.
Next press "0" to Disable or "1" to Enable the doorbell option followed by the # key.
Next press the
*
key (Yellow LED flashes rapidly).
Next press the
*
key (Yellow LED will flash slowly).
Example: 30 # 5 # 1 #
* *
(This will enable the doorbell function).
Example: 30 # 5 # 0 #
* *
(This will disable the doorbell function).
Continue programming or press the
*
key again to exit.
To set the Doorbell Option for continuous or timed operation:
Enter Programming Mode: 99# (Master code)
*
Next press Command number 32 followed by the # key.
Next press "0" for the doorbell option followed by the # key.
Next press "0" for continuous (Or enter a time of 1 trough 99 for timed output.) doorbell operation,
followed by the # key.
Next press the
*
key (Yellow LED flashes rapidly).
Next press the
*
key (Yellow LED will flash slowly).
Example: 32 # 0 # 0 #
* *
(This will enable the doorbell function for continuos output).
Example: 32 # 0 # 1 #
* *
(This will enable the doorbell function for a 1 second output).
Example: 32 # 0 # 20 #
* *
(This will enable the doorbell function for a 20 second output).
Continue programming or press the
*
key again to exit.
Step 8: Enabling or disabling keypad illumination or dimming:
The backlighting dims 15 seconds after the last keypress. It also dims 5 seconds after exiting
programming mode. This option is enabled by default.
To enable/disable keypad illumination:
Enter Programming Mode: 99# (Master code)
*
Next press Command number 30 followed by the # key.
Next press "3" for the backlighting option followed by the # key.
Next press "0" to Disable or "1" to Enable the keypad illumination option followed by the # key.
Next press the
*
key (Yellow LED flashes rapidly).
Next press the
*
key (Yellow LED will flash slowly).
Example: 30 # 3 # 1 #
* *
(This will enable keypad illumination).
Example: 30 # 3 # 0 #
* *
(This will disable keypad illumination).