AGFA M4F - Manual (Page 6)

Global Services North America Compressed Air Supply
Wilmington MA 01887
Engine Air Connection: An adapter (shown below) is needed to connect the air hose from the air
regulator to the printer. This should be purchased locally.
Compressor:
3 - 5 HP, min 60 - 80 gallons or better tank. The compressor
regulator should be set between 105 - 110 PSI for trip OFF and
to 85 PSI to trip ON.
Engine Air Pressure:
Air from the compressor, going to the Anapurna must be
regulated to 80 PSI. The Air regulator must be supplied by
the customer and located near the engine.
Engine Air Volume: .28 CFM (2 gallons/per minute usage rate)
Compressor Air Quality: Air Filters are required to eliminate moisture (No Water/No Oil)
Air - Water – Oil filtration must be purchased seperately
Sample Adapter for the 6 mm air line to the printer. The 6 mm air line
comes with the printer, approximate length is 1 meter.
Recommended:
Compressor, 60 G 5HP
Compressor Single Stage Compressor, Motor Running HP 5, Free Air
CFM @ 90 PSI 16.0, @ Max Pressure 14.2, Volts 208-230, Phase 3, Amp
Draw 13.4-13.2/6.6, Tank 60 Gal, Tank Type Vertical, FNPT Outlet 3/4 In,
Maximum Pressure 140 PSI, Duty Cycle 80/20, Pump Type Cast Iron,
Pump Oil Capacity 17 Oz, Splash Lubrication, Torxter Not Required,
Thermal Protection, Stationary, For Shop or Maintenance Facility General
Air Tool Operation, Length 23 In, Width 31 In, Height 71 Inches
Source: www.grainger.com item # 4ME98
Compressor, 3 HP
High Performance Cast Iron Air Compressor, Motor Running Power 3.0
HP, Free Air Flow @ Maximum Pressure 10.3 CFM, Free Air Flow @ 90
psi 11.3 CFM, Maximum Pressure 135 PSI, Phase Single, Voltage Rating
230 Volts, Current Rating 14.7 Amps, Tank Capacity 60 Gallons, Tank
Type Vertical, Height 66 Inches, Length 20 Inches, Width 23 Inches, NPT
Outlet (F) 1/2 Inches, 60 Hz
Source: www.grainger.com item # 4YW09
Questions? Contact 800-879-2432 and ask for an Anapurna Specialist 6