Avanti WCR682SS-1 - Manual (Page 10)

10
OPERATING YOUR WINE CHILLER
It is recommended you install the Wine Chiller in a place where the ambient temperature is between
23º-26ºC/ 72º-78ºF. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extreme cold or hot
conditions may cause interior temperatures to fluctuate. The range of 5º-18ºC/40º-65ºF may not be
reached.
Recommended Temperatures for Chilling Wine
.
Red Wines 15º - 18º C 58 – 65º F
Dry/White Wines 9º - 14º C 48 – 57º F
Rose Wines 10º - 11º C 49 – 51º F
Sparkling Wines 5º - 8º C 40 – 47º F
 ON/OFF POWER
To turn OFF the appliance, touch the mark and hold for 2 seconds.
 SETTING THE TEMPERATURE CONTROL
• You can set the temperature as you desire by touching the UP or DOWN mark. When you touch
the two marks for the first time, the LED readout will show the original temperature set at previous
time (the temperature preset at the factory is 12ºC/54ºF).
• The temperature that you desire to set will increase 1ºF or 1ºC if you touch the UP mark once, on
the contrary the temperature will decrease 1ºF or 1ºC if you touch the DOWN mark once.
• When you store mostly red wines, the temperature which you control by touching the above two
marks need to be set at between 15º - 18ºC/58º - 65
°F and the LED lamp under “RED” will be lit
red.
• When you store mostly white wines, the temperature needs to be set at between 9º - 14ºC/48º -
57
°F and the LED lamp under “WHITE” will be lit green.
• When you store mostly sparkling wines, the temperature needs to be set at between 5º - 8ºC/40º -
47
°F and the LED lamp under “SPARKL” will be lit amber.
• The temperature inside the unit will be appeared in blue color in the display window.
NOTE:
• If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine Chiller will not start.
• When you use the wine chiller for the first time or restart the wine chiller after having been shut off
for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation
time. Once the wine chiller is running for a few hours everything will be back to normal.
You can select temperature display setting from Fahrenheit to Celsius degree by touching the ºF/ºC
mark. Fahrenheit or Celsius degrees indicator will appear in blue color in the temperature display
window.