Auralex Acoustics Roominators Designer Series - Manual (Page 3)

C.
T’Fusors combat hot spots and nulls by alleviating flat, reflective
room surfaces with scientifically designed surfaces of varying shapes,
sizes and angles. Standing waves and flutter echoes are minimized
without significantly reducing acoustic energy in the space. Placement
of T’Fusor 3D Sound Diffusors is largely subjective. The most popular
choices are either on the rear wall and rear portion of the ceiling behind
the listening position or centered between the listening position and the
speakers on the ceiling as pictured. The best way to install the T’Fusors
is with mechanical fasteners such as screws or nails. Be sure to rotate
each T’Fusor 90° from the adjacent one for best results. Also, stuff
the back cavity of each T’Fusor with insulation, extra Studiofoam, or
blankets to reduce resonance and increase T’Fusor performance.
D.
GRAMMA is an amplifier/subwoofer
flotation device that helps reduce sound
transmission (especially low frequencies) by
decoupling the speaker enclosure from the
existing structure utilizing high-density foam.
Players, engineers, and listeners alike should
enjoy increased tonal definition and clarity in
effects/processing. GRAMMA can be used to
isolate instrument amplifiers, stage monitors,
and subwoofers from tracking room floors, live
stages, even the floor of a home theater.
E.
MoPADS are high-density foam products
that are designed to decouple your speakers
from any surface they set on in your room,
whether that be a desk, shelf or speaker
stands. This will “tighten” the tone of your
monitors - especially at the low end - and help
to reduce the amount of vibration transferred
to other gear that would normally be coupled
with the monitors, thus degrading your sound.
Roominators D240xi-DST™ Kit