Impulse 2105R - Manual (Page 9)

Hardware Installation
Do not connect the device to a USB port until the
software has been successfully installed.
The 2105R requires no user hardware configuration. Once you have installed the
software simply plug the 2105R into an available USB port. The drivers that were
installed during the software installation process will automatically be used to
configure the adapter.
NOTE: Once the device has been connected, the Found New Hardware wizard will
appear twice – first for the USB hub, and then for the serial port that you are
installing.
The following instructions are applicable to the Windows XP operating system and
may vary depending on your version of Windows.
1. After the software installation is complete, plug the 2105R into an available
USB port on the computer or USB hub.
2. A ‘Found New Hardware’ alert will appear above the system tray.
3. The ‘Found New Hardware Wizard’ will appear.
4. Choose ‘No, not this time’ and click ‘Next’ to proceed.
© Sealevel Systems, Inc. - 7 - SeaLINK+232-DB9 User Manual