L-com WL05U-G/GI Series Kits - Manual (Page 4)

Router Installation:
Conduct a Site Survey to determine the best location for the system. Once located,
install the Router in an appropriate location. Follow the Router mounting instructions
for specific mounting details.
Open the access cover by depressing the two tabs. Slide the PC Card into the PC
Card Slot and plug in the pigtail cable as shown. Then replace the access cover:
Connect the Pigtail Cable between the PC Card and the Amplifier/DC Injector input.
Install the Antenna
NOTE: The antenna system shall be installed ONLY by experienced antenna
installers who are familiar with local building and safety codes, and wherever
necessary have been licensed by appropriate government regulatory bodies.
Failure to do so may void the Product Warranty, as well as expose the end-user
to legal and/or financial liabilities. Hyperlink Technologies, its agents, resellers
or distributors, are not liable for injury, damage, or violation of government
regulations that may arise from failing to comply with the guidelines described
in this document.
Mount the antenna according to the specific installation instructions for the model you
are installing. When choosing the antenna site you must observe the following
exposure limits:
The table contained in Appendix B of this manual identifies which antennas are
considered “fixed” and which are “mobile”. When this device is installed as a
fixed-mount application there is a minimum required separation distance of one
100 cm between the antenna and all persons during normal operation. All
mobile antennas must be mounted at a minimum distance of 20 cm from users.
Once the antenna is installed connect the antenna to the amplifier using the antenna
cable.
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.