L-com HG2424G - Manual (Page 2)

IP-00002 Rev. C – 04/05 Page 1/3
HyperGain™ HG2424G
2.4 GHz dBi Reflector Grid Antenna
Installation Instructions
Antenna Components Included:
(1) Antenna Feedhorn Assembly
(1) Feed Reflector
(1) Small Self-tapping Screw
(2) Grid Section Halves
(2) #M6 Stainless Steel U-Bolts w/nuts, flat and lock washers
(2) Mast Clamps
(1) Aluminum “L” Bracket
(4) #M5 x 15mm Machine Screws w/nuts, flat and lock washers
(4) #M6 x 30mm Machine Screws w/nuts, flat and lock washers
Antenna Assembly Instructions:
Feedhorn
Reflector Grid
Lock Washer & Nut Feed Reflector
Small Self-Tapping Screw
#M5 Machine Screw
Install the Feed Reflector to the front of the
Feedhorn using the small self-tapping screw.
Assemble the halves of the Reflector Grid using
(4) #M5 machine screws with lock washers, flat
washers and nuts as shown.
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.