Lectrosonics R5a - Manual (Page 11)

Specifications and Features
Operating frequencies (MHz):
Block 525
Block 21
Block 22
Block 23
Block 24
Block 25
Block 26
Block 27
Block 28
Block 29
Block 30
Block 31
Block 32
Block 33
Number of frequencies:
Channel spacing:
Service Center)
Frequency control:
Sensitivity:
Signal/Noise ratio:
Squelch quieting:
AM rejection:
525.000 - 550.500
537.600 - 563.100
563.200 - 588.700
588.800 - 614.300
614.400 - 639.900
640.000 - 665.500
665.600 - 691.100
691.200 - 716.700
716.800 - 742.300
742.400 - 767.900
768.000 - 793.500
793.600 - 819.100
819.200 - 844.700
844.800 - 862.000
256 per block (using 26 MHz wide band)
100 kHz (programmable to 25kHz by Authorized
Crystal Controlled Phase Locked Loop
1 uv (20 dB SINAD)
95 dB A-weighted
50 dB
50 dB, 10 uv to 100 mv
Modulation acceptance: ±20 kHz
Spurious rejection: Greater than 70 dB
Third order intercept: 0 dBm
Frequency response: 100 Hz to 10 kHz, (±1db)
Pilot tone: 29.997 kHz, 4.5 kHz deviation
(fixed crystal controlled)
Audio output, headphone: 1 Vrms into 50 ohms minimum
Antenna: Headphone cable
Programmable memory: 5 frequencies
Front panel controls: Single knob controls Audio Output Level, Power On,
Programming and Scan Frequency Selection
Indicators: 1 tricolor LED Indicator for power on, blinks to
indicate channel number, blinks fast during scan,
and turns yellow or red for low battery.
Power requirement: Single 9V Alkaline Battery for approximately 8 hours
operation.
Power consumption: 60 ma.
Weight: 7.3 oz with battery
Size: 3.6 x 2.4 x 0.8 inches (housing only, belt clip and
knob extend beyond the housing.)
Specifications subject to change without notice.