Lectrosonics MI33ST - Manual

MI33ARA/MI33AST
TECHNICAL DATA
Active Instrument Cables
MI33ARA
• For use with non-Servo Bias transmitter
inputs including LM, IM and UM400, and with
early SM transmitter inputs
• Built-in JFET active preamp for optimum
interface with instrument pickups
• Designed for active musicians who demand
rugged, high quality equipment and the best
sound quality available
• 30 inch overall length
PIN
1
2
3
4
1
2 3
4 5
SHIELD
TIP
SLEEVE
1/4 " PLUG
Preamp
AUDIO
SHIELD
AUDIO
PWR
3 k TA5F
5 PLUG
Simplified diagram of MI33AST cable assembly
Other cables available:
MI33PRA and MI33PST
Passive cable for high output active pickups and line
outputs from keyboards and other audio equipment.
MI39ARA and MI39AST
For use with all transmitters, including IM, LM, UM400
models, SM Series, SMa Series, LMa and UM400a
models.
23 June 2008
MI33AST
Transmitter Setup Instructions
Start with the input gain on the transmitter at about
10 o’clock for most transmitters (12 o’clock for the
IM). Play at the same level expected during the
performance and adjust the input gain until the -20
LED flickers red (indicating +0 dB) during the loud­
est passages.
Adjust transmitter gain for
occasional red flashes at -20
SM, MM LM, IM UM, UH
-10
-20
PWR
-10 -20
-10
-20
*NOTE: MI33A cables do not function properly
with Servo Bias input transmitters
Rio Rancho, NM, USA
www.lectrosonics.com