Lectrosonics SPNDNT - Manual (Page 23)

Installation and Quick Start Guide
Rio Rancho, NM 23
Set up the inputs for the microphones connected to the
SPNTrio. Adjust the gain so the level is close to 0dBu
during normal speech.
Select SPNTrio Inputs tab
Route the inputs as follows:
• In 1 to Mix 1 and Mix 5
• In 2 to Mix 2 and Mix 5
In this example, Mixes 1 and 2 are routed to the local
sound system in a mix-minus pattern. Mix 5 delivers
the audio from the local microphones into the Dante
network.
Select SPNTrio Matrix tab
Route the Dante network channels in the SPNDNT as
follows:
• In 1 to Mix 3
• In 2 to Mix 4
This will provide the audio source from the network to
the local sound system.
Select SPNDNT Matrix tab
Select the signal sources for the output channels on
the SPNTrio to feed the local sound system.
Select SPNTrio Output Source tab
Output Channel Signal Source
1 Mix 2
2 Mix 1
3 Mix 3
4 Mix 4
Outputs 1 and 2 are configured in a “criss cross” man-
ner to imply that there is a mix-minus arrangement in
the local sound system.
Outputs 3 and 4 deliver the audio from the other two
ASPEN systems on the network into the local sound
system.
(see next page)