Aquapro Fish Feeders ADF-150DX - Manual (Page 6)

PAge 6
(Illustration F) (Illustration g)
9
Close the lid and then locate the latch and
striker. First, take the striker portion and install
it onto the lid with the j-lip facing upward. These
holes are already in place on the lid so install the
5/32” x 15/32” Bolts and the 5/32” Washers
with the heads on the outside of the hopper and
the threads facing into the hopper. Next, place the
5/32” Nylon Lock Nuts on the bolts and tighten
securely. Locate the two (2) smooth marked spots
on the hopper piece. The smooth spots align
vertically on the outside surface just underneath
the top lip. You may have to look closely to locate
the markings as they may not be real obvious.
Once located, take your cordless drill and a 5/32”
drill bit and drill out the two (2) holes where the
markings are located (Illustration F). Now take the
latch and make sure that it is in the closed position
(not extended); lay the latch portion over the j-lip to
align the latch on the hopper. Now open the latch
and take two (2) 5/32” x 15/32” bolts, washer and
nylon lock nuts and secure the latch side into place
using the two mounting holes that were just drilled.
Make sure that the latch is properly aligned with the
striker so when the lid is closed it locks properly.
DO NOT OVeR TIgHTeN AS STRIPPINg MAY OCCUR
(Illustration g).