Lectrosonics DNT16i - Manual (Page 11)

Installation and Quick Start Guide
Rio Rancho, NM 11
DNT Control Panel Software - Signal Flow
Configuration
In each processor:
The following signal connections and routing must be
configured before the processor will pass signals.
• Inputs
• Matrix crosspoints
• Outputs
In the Dante Network:
• Transmit Channels (device outputs)
• Subscriptions (device receive channels)
Be sure to save your settings into a Preset within the
processor and to a file on the computer as a backup.
Follow the instructions below to make a connection to
the processor.
DNT Software - USB Connection
Connect the processor to the computer via the front
panel USB jack. Launch DNT Control Panel and click
on Connect -> Connect via USB... in the upper left
corner of the screen.
Click on Connect via USB...
When the next screen opens, the connected processor
will appear in the screen. Click on OK to continue.
DNT Software - Ethernet Connection
Connect the processor to the network via the rear
panel Ethernet jack. The easiest way to establish an
Ethernet connection is to first connect to the processor
via the USB port to discover or assign the IP address.
If DHCP is enabled and the IP address is assigned
by a network server, the address will appear in the
Network Settings dialog box. Otherwise a static IP
address may be entered into the same dialog box. See
page 10 for detailed network port setup instructions.
Launch
DNT Control Panel and then open the setup
screen for the processor. Click on Device Settings ->
Network. A dialog box will open displaying the IP ad-
dress and TCP Port number.
Once the IP address and TCP Port number are veri-
fied, launch DNT Control Panel and click on Connect
-> Connect via Network... in the upper left corner of
the screen.
Click on Connect via Network...
In the next screen, verify or enter the IP address of the
processor in the upper part of the screen, then click
on Search. The processor will appear. Click on OK to
continue.