Lectrosonics Long Ranger II User Manual
Page 16
SPECIFICATIONS
LONG RANGER II
Operating frequency:
150 to 216 MHz
Audio power output:
33 Watts, RMS, into 8 Ohms
Distortion:
less than 1%
Amplifier freq. response:
50Hz - 20kHz; +0, -3 dB
Max. audio output(SPL):
140 dB at 3 feet
FM deviation:
±15kHz
Wireless operating range:
Up to 750 feet
RF signal-to-noise ratio:
96dB, A weighted
Speaker:
6" x 12" re-entrant horn
Weight:
16 lbs., 13 ozs.
Dimensions:
15" high, 6 3/4" wide, 9 1/4" deep
M170 TRANSMITTER
Operating Frequency:
150 to 216 MHz
RF Power Output:
50 mW
Deviation:
±15kHz
Spurious radiation:
60dB below carrier
Frequency stability:
±0.002%
Equivalent input noise:
-126dB
Input sensitivity:
8mV to 1.6V for full modulation
Input compressor:
Soft compressor; 12dB range
Electret bias:
+5 Volts DC (positive bias)
Antenna:
Input cord or microphone
Size:
1.1 x 2.3 x 3.3 inches
Weight:
4 ozs. including battery
M170 and M170-XLR transmitters are FCC type accepted under the
following parts:
Part 90 (150-172 MHz)
Part 74 (174-216 MHz)
SR170-LR "ADD-ON" RECEIVER
Operating frequencies:
150 to 216 MHz, crystal controlled
Sensitivity:
1.0uV for 20dB SINAD
2.0uV for 50dB S/N ratio
Signal/noise ratio:
90dB flat; 96dB A-weighted
Squelch quieting:
Greater than 96dB
AM rejection:
-40dB (10 uV to 0.1 V input levels)
Modulation acceptance:
±15kHz
Spurious/image rejection:
Greater than 100dB
Power requirements:
External 12V DC
Power consumption:
40mA
Weight:
7.4 ounces
Dimensions:
1.1 x 2.8 x 4.6 inches
15