Lectrosonics VP18R - Manual (Page 7)

Voice Projector Portable PA System
DISTORTED SOUND FROM SPEAKER 1) Volume set too high. Reduce volume control.
2) Excessive wind noise or breath “pops”. Use windscreen
on mic.
3) Batteries very low. As the batteries discharge you have to
turn up the volume. When the volume knob is turned all the
way up and you’re still not getting much volume out of the
system, the amplifier is being driven to its limit so it
produces a distorted sound.
EXCESSIVE FEEDBACK 1) Volume too high. Reduce volume control.
2) Microphone too far from sound source (requiring the
volume to be turned up to compensate). Speak closer to
the mic or move mic closer to sound source.
3) Microphone too close to, or directly in front of, the horn or
speaker. As mentioned in the operating instructions on
page 4, the unit should be placed between you and the
crowd. If you stand in front of the unit while you use it,
feedback can occur. This problem is easily solved by
moving behind the unit.
ACCESSORIES
Part. No. Description
CH-40 Replacement charger
MC-16C Coiled microphone cord; 1/4" male to male (extends to 16 ft.)
MM-16 Straight 16 ft. microphone cord
RK-51 Foam windscreen for hand-held microphones
RM-121S Hand-held cardioid dynamic microphone
14040 Replacement strap for VP18R
Rio Rancho, NM – USA 7