Liquid Controls HML110 IOM - Manual (Page 13)

HML 110
13
110_EN_LC_5_3_6X.doc
For converters without a keyboard (blind version),
functions are programmed utilizing the IF2 device:
SHORT PRESSING (< 1 SECOND):
Enters/leaves the selected function
Enables the main menu for the converter configuration
Cancels the selected function under progress
LONG PRESSING (> 1 SECOND):
Leaves the current function, in the Quick start or Main menus.
Enables the ‘EXECUTE?’ prompt in the Main menu functions, and total reset
request (when enabled) from the required function
Confirms the selected function
SHORT PRESSING (< 1 SECOND):
Moves the cursor rightwards on the input field
Accesses to the following subject in the Quick start or Main menus
Changes the display of the process data
LONG PRESSING (> 1 SECOND):
Moves the cursor leftwards on the input field
Accesses the previous subject in the Quick start or Main menus
SHORT PRESSING (< 1 SECOND):
Increases the numeric figure or the parameter selected by the cursor
Accesses the previous subject when in the Quick start or Main menus
Batch start/stop (when enabled)
LONG PRESSING (> 1 SECOND):
Decreases the numeric figure or the parameter selected by the cursor
Accesses the next subject in the Quick start or Main menus
Key pad function
ACCESS TO THE CONVERTER KEYPAD
KEYBOARD
M3 The keypad is accessible by loosening the 4 cover screws,
and opening the front cover of the converter. Three KEYS
are set aside of the M1 terminal block allowing the user to
change screen display visualizations and select functions.
Blind converters