Layout and storage – Amcor WV-100 User Manual
Page 14
12
Layout and Storage
Ball Bearing Shelf:
To move a ball bearing shelf, fi rst
remove all bottles, loosen the
screws on the shelf, slide out the
shelf, remove the sliding guides
from the walls, then refi t them as
shown below, and fi x the screws.
Recommendations
Your cabinet was designed to store a maximum number of bottles in total security.
We recommend that you observe the tips below to optimize loading.
• Spread your bottles out as evenly as possible over the shelves, so that weight is not concentrated
in one point. Also make sure your bottles do not touch the back of the cabinet, or the step at
bottom. Also make sure that bottles are not all grouped together at the top or bottom of
the cabinet.
• Observe the loading instructions provided in section 6, according to the type of storage fi xtures
with which your cabinet is equipped, and never stack bottles on a sliding shelf.
• Never try to pull out more than one sliding shelf at a time.
PLEASE NOTE
Before modifying your Wine Vault's original confi guration in any way, be sure to ask your dealer
for advice.
Guide
Wall
Guide
Wall