Magnum Venus Plastech PATRIOT 10:1 ADHESIVE SYSTEM - Manual (Page 17)

Patriot 10:1 Adhesive System Operations Manual
Rev. 03/2014 Page | 17
Hose Connections:
1. Attach Yellow Flush Tube (solvent to the gun) to the outlet (SOLVENT) side of the flush tank (see fig. 1)
2. Attach ¼ inch poly tube from the air manifold to the flush tank regulator (AIR). (see fig. 1)
3. Connect the Air Purge supply to the Air purge regulator on the air manifold (see fig. 2
Figure 2
4. Connect the Resin Hoses from the gun to the outlet port on the material manifolds. The resin hoses
are color coded to match the fluid section and material manifold.
5. Connect the Green Signal line from the gun to the pressure valve on the material manifold (see fig. 3).
Figure 3
6. Connect the Gun Air Supply from the back of the gun handle to the air manifold.
7. Install the proper fitting into the Main Air Supply Ball Valve and connect the air supply. The Ball Valve
comes with a 1/2" NPT Female port. (see fig. 4) (Use caution when using quick disconnects as they
may restrict air flow.)
Green Signal line from the
Gun to the Pressure Valve on
the Material Manifold.
Air Purge Regulator connection
Air Purge Regulator