Magnum Venus Plastech PATRIOT PAT-CP-0980-S - Manual (Page 18)

PAT-CP-0980 Catalyst Pump Manual
Rev. 03/2013 Page | 18
Catalyst Pump Disassembly:
Warning: Never use any type of grease or lubricants on catalyst pump or fittings.
Clean parts in distilled water. Lay parts on clean paper towels that will be reused.
Note: Do not remove fitting body (PAT-CP-0505) from outlet body. It is also
recommended the catalyst jug and screens are cleaned using distilled water. Cut off
½” on the end of ½” poly tubing feed hose which attaches to the catalyst pump inlet
fitting to avoid leaks.
1. Loosen the jam nut (50820-1) from the inlet body (PAT-CP-0902) and then un-
screw the inlet body from the outlet body (PAT-CP-0903).
2. Un-screw the plastic retaining nut (PAT-CP-0906) from the outlet body (PAT-CP-
0903).
3. Pull the ball joint linkage and piston rod (PAT-CP-0908) up through the top of the
outlet body (PAT-CP-0903). Remove the ball joint linkage from the fluid rod (PAT-
CP-0908) and slide the two cup seals (PAT-CP-0901) and leak spacer (PAT-CP-
0907) from the piston shaft.
4. Remove the seal retainer (50530-1) and piston seal (02014) from the piston body
(50440-1). Remove the piston body, ball (9201-1-7) and spring (04013-1) from
the rod (PAT-CP-0908).
5. Remove the inlet body tube fitting (4101-8-1) and outlet body hose fitting (51501-
1)
6. Remove from inlet body (PAT-CP-0902) ball (03072) and o-ring (O-S-016). A
scribe will be needed to remove the ball seat o-ring (O-F-112).
Wash all parts to be reused with distilled water. Inspect the piston rod and cylinder for
wear.