Magnum Venus Plastech APS E-FIT-F-CMB-APS-6 - Manual (Page 14)

Chapter
5
Tungsten Carbide Spray
Nozzle Information
TUNGSTEN CARBIDE SPRAY NOZZLE SELECTION
X - XXX
For MG-3000 use . . . . . . . M2------ ------Orifice size in thousandths of an inch
For LW-2500 use . . . . . . . . LW------
For ATG-3500 use . . . . . . . . .ATG------ ------1/2 spray pattern width at 12” away
For ATC-4000 use . . . . . . . . . ATC------ (double for actual width)
For MIX-1000 use . . . . . . . . . ALCEL------
For MIX-6000-C & MIX-5500-G use . . . . . MIX------
**It is important to select the proper spray nozzle in order to get the optimum efficiency out of your MVP
Spray System**
DETERMINING FACTORS
Pattern Width - The type and size of the mold being sprayed will determine the pattern width. Too wide
may produce waste.
Output - The orifice size and fluid pressure determine the material output of a spray nozzle. The following
chart will help in selecting the proper spray nozzle.
BASED ON FLOW OF WATER
Standard Orifice Size GPM - 500 PSI GPM - 1000 PSI
.015 .12 .16
.018 .18 .25
.021 .24 .33
.023 .28 .40
.026 .35 .50
.031 .53 .75
.036 .71 1.00
.043 1.10 1.50
.049 1.30 1.85
.052 1.40 2.00
.058 1.60 2.50
.062 2.10 3.00
.068 2.50 3.50
.072 2.80 4.00
.078 3.50 5.00
.085 3.90 5.50