Magnum Venus Plastech RT-1000 PUSH BUTTON TRIGGER - Manual (Page 16)

RT-1000 Remote Trigger Manual
Rev. 12/2012 Page | 16
Making Connections:
To make the connections disassemble the connector plug attached to the side of the
control box. Use 1/4 inch poly tube, MVP number MS-2052-1 and Hose Clamp 7701-2-1
to make connections between the connector plug and component. Connections are made
by sliding the Hose Clamp onto the correct poly tube pushing the poly tube onto the
correct barb fitting and thread the Hose Clamp over the poly tube and barb fitting. It is a
good idea to mark both ends of each piece of tubing to aid in trouble shooting and
plumbing.
Below is a diagram of the signal connections for the RT-1000.
S
T
A
R
T
S
T
O
P
R
E
S
E
T
AIR SUPPLY FROM MANIFOLD
TO RESIN METER RESET VALVE
TO PILOT VALVE 09187 (GUN OFF)
TO PILOT VALVE 09187 (GUN ON)
It is best to organize and plan the routing of the tubing as it is installed to make the
installation easier and look better. Use plastic ties or tape to pair similar tubing and
control the tubing bundle.
Air Supply In:
1. Locate or create an air supply from the air manifold.
2. Mark both ends of the poly tube appropriately and slide the hose clamp onto the tube
and then attach it to the barb fitting on the bottom of the valve. (see diagram above)
3. Connect the other end of the poly tube to the air supply fitting located on the air
manifold.