Mallory Ignition Lakewood safety bellhousing 15060 User Manual
Page 4
POSITION:
IMPORTANT: All fasteners must be used in their proper location
for the bellhousing to meet S.F.I. 6.1 safety requirements.
SAFETY BLOCKPLATE FASTENER REQUIREMENTS
AND LOCATION
KNOCKOUT REMOVAL INSTRUCTIONS
CAUTION:
Wear safety glasses!
1.
Place blockplate on heavy table or solid surface with notched side of “knockout” facing up.
2. Support underside of “knockout” around outside perimeter area.
3. Using a heavy hammer and blunt tool such as a drift pin, start at recessed corner and
strike “knockout” sharply. Continue until part drops out.
Note: If distortion to blockplate occurs, lay on flat surface and straighten before installing.
Area should be filed smooth if any rough edges or burrs remain.
REMOVE KNOCKOUT WHEN USING A
BLOCK-MOUNTED STARTER. CARE MUST
BE TAKEN TO NOT BEND OR
DISTORT BLOCKPLATE DURING REMOVAL
OF KNOCKOUT.
SEE PROCEDURE BELOW.