Mallory Ignition Lakewood REAR UPPER CONTROL ARMS 21101_21102_21103 - Manual

Features:
• Heavy gauge steel eliminates flex for
increased traction
• Completely bolt-on, no welding required
• Delrin bushings for positive suspension
control and stability
• Legal for NHRA Stock Eliminator Classes
IMPORTANT!
Read this instruction sheet completely so that
you thoroughly understand it and are familiar
with the procedure before attempting installation.
WORK SAFELY!
Installation of these control arms requires
working underneath vehicle.
USE EXTREME CARE AND CAUTION WHEN
WORKING UNDERNEATH VEHICLE.
Never get near or under vehicle until you are
confident that it is safely supported and will not
move or fall from its raised position.
DO NOT USE A BUMPER JACK.
PREPARATION FOR INSTALLATION
1. Place vehicle on a solid level surface to ensure
safe installation
2. Place wheel blocks in front of and behind both front
wheels to prevent movement in either direction.
3. Raise rear of vehicle and support flat area of chassis
in front of lower control arm attaching point using
approved automotive support stands having
adequate load capacity. DO NOT put support stands
under the axle housing. Note: Raise vehicle high
enough to allow adequate clearance for coil
spring removal.
CAUTION
DO NOT BEGIN THIS INSTALLATION UNTIL YOU ARE
CONFIDENT THAT VEHICLE IS SECURE AND SAFELY
SUPPORTED!
CONTROL ARM INSTALLATION
NOTE
We recommend working on
only one side at a time.
1. Remove both rear wheels.
2. Apply penetrating oil or rust release lubricant to
front and rear mounting bolts of upper control arms.
3. Raise axle housing up approximately 2"
(a hydraulic floor jack is recommended for
this procedure).
4. Using a hex socket and wrench, remove one upper
control arm.
5. Install the control arm to chassis and axle
housing brackets using the mounting bolts and
nuts supplied.
Note: Clean and lubricate axle and chassis control
arm mounting brackets with a good quality chassis
grease to ease installation.
6. Tighten front and rear control arm mounting bolts to
80 ft./lb. torque.
7. Follow the same above procedure for installation of
Lakewood Control Arm on other side of vehicle.
8. Lubricate control arm bushings with a good quality
chassis grease.
9. Install wheels and properly tighten lug nuts to wheel
manufacturers specifications.
10. Carefully remove support stands and lower vehicle
to ground.
THIS COMPLETES THE INSTALLATION.
YOU CAN NOW ROCK-N-ROLL!
IMPORTANT!
Periodically check to make sure that all mounting
hardware is securely tightened. Use a good
quality chassis grease to keep bushings and
sleeves properly lubricated.
H.D. REAR UPPER CONTROL ARMS
INSTALLATION INSTRUCTIONS
Part #21101, #21102, #21103
LAKEWOOD INDUSTRIES IS A DIVISION OF MR. GASKET INC. • CLEVELAND • OHIO • WWW.LAKEWOOD-INDUSTRIES.COM ©2006