Mallory Ignition Mallory ACTIVE POWER FILTER 29351 User Manual

Installation instructions, Active power filter, General information

Advertising
background image

MALLORY IGNITION IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
550 MALLORY WAY, CARSON CITY, NV 89701
(775) 882-6600

FAX (775) 887-4326

www.mrgasket.com

FORM 1359

(REV. C) 7/03

MADE IN U.S.A.

PRINTED IN U.S.A.

ACTIVE POWER FILTER

PART NO. 29351

Parts Included in this kit:

1 Active Power Filter

1 Velcro

®

Hook and Loop, 1" x1-1/2"

GENERAL INFORMATION

The Active Power Filter is designed for UNILITE

®

and MBI Ignition

Systems that experience failures with the ignition modules from voltage
spikes (voltage transients, power surges). Voltage spikes are associated
with “noisy” electrical systems from electrical defects such as worn
alternator brushes, corroded or oxidized electrical connections and similar
electrical problems. Voltage spikes are clamped and regulated by the
Active Power Filter from damaging the UNILITE

®

Ignition Module.

NOTE: The Active Power Filter does not resolve failures with MBI
and UNILITE

®

Ignition Modules associated with: a) the absence of an

ignition ballast resistor in applications that require an ignition ballast
resistor; b) improper wiring.

INSTALLATION PROCEDURE

Step 1

Disconnect the distributor female connector from the distributor wire har-
ness male connector.

Step 2

Connect the distributor female connector to the Active Power Filter male
connector. See Figure 1.

Step 3

Connect the Active Power Filter female connector to the distributor wire har-
ness male connector. See Figure 1.

Step 4

Mount the Active Power Filter to the distributor housing with Velcro

®

.

ACTIVE

POWER

FILTER

Figure 1

INSTALLATION
INSTRUCTIONS

DISTRIBUTOR (TYPICAL)
ALL UNILITE

®

DISTRIBUTOR SERIES NOS. 37, 38, 45, 46, 47, 83, 86, 91, AND 93

ALL UNILITE

®

BREAKERLESS ELECTRONIC CONVERSION KITS

ALL MBI DISTRIBUTOR SERIES 42, 50, 57 AND 87
ALL MBI BREAKERLESS ELECTRONIC CONVERSION KITS

DISTRIBUTOR WIRE HARNESS

NOTE: THE DISTRIBUTOR WIRE HARNESS REMAINS
CONNECTED ACCORDING TO THE INSTRUCTIONS
SUPPLIED WITH YOUR IGNITION SYSTEM.

MALE

CONNECTOR

FEMALE

CONNECTOR

MALE

CONNECTOR

DISTRIBUTOR

FEMALE

CONNECTOR

(MOUNTING LOCATION SUGGESTION)

Advertising