Mallory Ignition Mallory HEI PERFORMANCE COIL 29212_29215 - Manual

HEI PERFORMANCE COIL
PART NO. 29212, Effective up to 5,500 RPM
PART NO. 29215, Effective from 4,000 to 7,000 RPM
LIST OF PARTS:
1 HEI Performance Coil
1 Rubber washer
1 Carbon brush and spring
1 Ground strap
4 Self tapping screws
INSTALLATION PROCEDURE
Step 1
Disconnect the battery (–) cable to cut power to the system.
Step 2
Disconnect wire harnesses from the distributor cap. There are more than one.
Remove the distributor cap and check for wear. Replace if necessary.
Step 3
Remove and discard the spark plug wire retainer and coil cover.
Step 4
Notice that the red wire from coil was positioned under the BATT (+) imprint on
the coil cover, and the white or yellow wire from coil was positioned under the
COIL (–) or TACH imprint on the coil cover. Gently lift (pull) each terminal
assembly and wire upward from each cavity in the distributor cap.
Step 5
Remove and discard the four coil mounting screws. Remove and discard the coil.
Step 6
Gently lift (pull) the ground strap upward from its cavity in the distributor cap, and
replace it with the new ground strap. Remove rubber washer and carbon brush
with spring from the distributor cap. Install new carbon brush with spring into the
distributor cap. Coat both sides of new rubber washer with dielectric grease and
install into the distributor cap.
Step 7
Hold the HEI Performance Coil above the distributor cap. Insert terminal
assembly with red wire into the cavity on the distributor cap where previous coil
terminal assembly with red wire had been. Insert terminal assembly with yellow
wire into the cavity on the distributor cap where previous coil terminal assembly
with white or yellow wire had been. Lower into place the HEI Performance Coil
onto the distributor cap. Make sure it is fully seated.
Step 8
Insert the four self tapping screws in the four holes on the top of the HEI
Performance Coil cover. Gently tighten each self tapping screw. Do not over
tighten self tapping screws or distributor cap damage may result.
Step 9
Install the distributor cap. Connect wire harnesses to the distributor cap where
each had been previously.
Step 10
Connect the battery (–) cable.
®
INSTALLATION INSTRUCTIONS
CARBON BRUSH
GROUND
STRAP
DISTRIBUTOR
CAP
RUBBER
WASHER
YELLOW LEAD
COIL (–)
RED LEAD
BATTERY (+)
SCREWS (4)
B ATT
( +)
G RD
C OIL
( –)
®
MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
550 MALLORY WAY, CARSON CITY, NV 89701
(775) 882-6600
FAX (775) 887-4326
www.mrgasket.com
FORM 1221
REV. C (10/99)
MADE IN USA
PRINTED IN USA