Mallory Ignition Mallory CT Pro Ignition Products 6800m - Manual

Mallory CT Pro Ignition Products
Part # Description Includes
6800M CT PRO IGNITION SYSTEM 2 CT PRO IGNITION BOXES, 2 CT PRO
IGNITION COILS, 1 DUAL COIL SELECTOR
AND 2 COIL WIRES PRE-MOUNTED ON AN
ALUMINUM PLATE
6864ARCA CT PRO IGNITION BOX 1 CT PRO IGNITION BOX
30460 CT PRO IGNITION COIL 1 CT PRO IGNITION COIL
29029 DUAL IGNITION PLATE 1 DUAL IGNITION PLATE
29000 DUAL COIL SELECTOR 1 DUAL COIL SELECTOR
Ignition tray
The Ignition tray is made from 1/8” aluminum and has a 12” X 12” footprint. The tray has a 3” tall front lip
for product identification. This lip will be facing the rear of the vehicle and is acceptable to hang off the
edge of the dash. The bend for the lip has a .50” radius so the overall front to back length of the tray is
12.65”
The coil terminals hang off the right and left side edges of the plate by around 1”. Special attention should
be paid when positioning your plate so the coil output terminals are at least 1” away from chassis ground to
prevent possible arching to ground.
The tray has 4, 11/32” holes that are 1” in from the corners of the 12” x 12” footprint. This makes the hole
center spacing 10”. We recommend using 5/16’ or smaller studs and washers to allow for slight variations.
The components are bolted through the plate so there are bolt heads on the bottom of the tray. We
recommend using .25” thick spacers or washers under the plate so the bolt heads do not contact the dash.