Little Colorado Toy Storage Box 58 - Manual (Page 2)

Quality Wooden Children’s Furniture and Accessories
Made in America • Established 1987
www . littlecolorado . com
Toy Stoprage Chest Assembly Instructions- Continued
Revised 10/10
by
E. Layton
• Now that you have the two sides
fastened to the back; slide the
Bottom panel in the bottom grooves
(The side with the Little Colorado
logo is the top side).
• Insert a Barrel Nut into the Back panel
Barrel Nut hole in relation to the Joint
Connector Bolt previously installed.
• Make sure the longest slot on the head
of the Barrel Nut is perpendicular to
the Joint Connector Bolt.
• Fasten the Side panel and Back panel
together. Start Joint Connector Bolt by hand
and after a few turns begin using the supplied
Allen wrench.
• Make sure Back panel fits inside groove.
Tighten bolt to a snug fit. Then unscrew one
full turn to allow adjustment.
• Now, repeat steps 1,2 and 3 for
second hole and to assemble
the other Side panel.
• Starting with a Side panel, insert one Joint
Connector Bolt in Joint Connector Bolt
hole.
• Repeat steps 1, 2 and 3 to attach
Front panel to body.
• With the box sitting flat on a hard
surface, tighten all eight bolts.
Bottom Panel
Panel Groove
1 2 3
4 5 6
Page 2 of 3
• Using the existing holes, attach bottom of
Lid Support to inside of Back with 2 #8 screws
• Be careful not to over tighten screws.
• Place Lid on top of the box and line
up existing holes located on outside
of the back panel to holes in hinge.
Attach hinge to back of box using 15
#5 screws.
• Be careful not to over tighten screws.
Lid
Body
Back
Lid Support
Partial view of Back/Front panel
Barrel Nut Holes
Joint Connector
Holes
Side Panel
Top
Bottom
Area of Detail