Specifications, Trouble shooting – Master Appliance UT-100Si Ultratorch Soldering Iron_Heat Tool User Manual
Page 7
Specifications
UT‑100Si
UT‑200Si
Overall length with soldering tip
262mm (10.3 in.)
302mm (11.9 in.)
Overall length with heat tip
247mm (9.7 in.)
285mm (11.2 in.)
Weight (when gas filled)
126g (5.4 oz.)
222g (9 oz.)
Approximate temp. soldering tip
250° - 500°C
250° - 530°C
(507° - 958°F)
(482° - 986°F)
Approximate temp. heat tip
650°C (1228°F)
540°C (1030°F)
Gas Capacity Container
28cc (1.6 cu. in.)
63cc (3.8 cu. in.)
Approximate Operating Time
Max. 2 hours
Max. 4.5 hours
(one gas filling)
at #3 setting
at #3 setting
Problem
Does not ignite
Low gas pressure
Low flame
Not enough heat
Probable cause
a. Empty tank
b. Clogged ejector
c. Fuel setting too high
a. Foreign object blocking tips
b. Cold fuel
a. Used-up catalyst
b. Low fuel
Solution
a. Refill with butane fuel
b. Replace with new ejector
c. Adjust switch ring or gas
control lever to lower setting
a. Clean out or replace tips
b. Hold unit in hand to allow unit
to warmup.
DO NOT HEAT HANDLE.
a. Replace with new tip
b. Refill with butane gas
Trouble Shooting
Note: Ultratorches utilize the energy produced while evaporating butane gas. Ambient
temperature affects operation. Adjust the unit as necessary.