Mastercool 69788 RECOVERY_RECYCLE_RECHARGE - Manual (Page 4)

4
SAFETY SUMMARY
The following safety information is provided as guidelines to help you operate your new system under the safest possible conditions. Any equipment
that uses chemicals can be potentially dangerous to use when safety or safe handling instructions are not known or not followed. The following
safety instructions are to provide the user with the information necessary for safe use and operation. Please read and retain these instructions for
the continued safe use of your service system.
SAFETY INFORMATION
Every craftsman respects the tools with which they work. They know that the tools represent years of constantly improved designs and
developments. The true craftsman also knows that tools are dangerous if misused or abused. To reduce risk of discomfort, illness, or even death,
read, understand, and follow the following safety instructions. In addition, make certain that anyone else that uses this equipment understands and
follows these safety instructions as well.
READ ALL SAFETY INFORMATION CAREFULLY before attempting to install, operate, or service this equipment. Failure to comply with these
instructions could result in personal injury and/or property damage.
RETAIN THE FOLLOWING SAFETY INFORMATION FOR FUTURE REFERENCE.
Published standards on safety are available and are listed at the end of this section under ADDITIONAL SAFETY INFORMATION.
The National Electrical Code, Occupational Safety and Health Act regulations, local industrial codes and local inspection requirements also provide a
basis for equipment installation, use, and service.
The following safety alert symbols identify important safety messages in this manual.
When you see one of the symbols shown here, be alert to the possibility of personal injury and carefully read the message that follows.
Never fill the tank to more than 80% of maximum capacity as this will not leave an expansion chamber for absorbing any pressure increases.
ELECTRICAL SHOCK HAZARDS
• To reduce the risk of electric shock, unplug the power supply cord from the outlet before attempting any maintenance or cleaning. Turning off
controls will not reduce this risk.
• Do not operate the machine with a damaged cord or plug — replace the cord or plug immediately. To reduce the risk of damage to electric plug
and cord, disconnect the power cord by pulling on the plug rather than the cord.
An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in a risk of fire, electric shock
and component damage. If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape as those on plug on recycler.
b. That extension cord is properly wired and in good electrical condition; and
c. That the wire size is large enough for the length of cord as specified below:
Length of cord in feet: 25 50 100 150
AWG size of cord: 16 12 10 8
MOTION HAZARDS
• Engine parts that are in motion and unexpected movement of a vehicle can injure or kill. When working near moving engine parts, wear snug fit
clothing and keep hands and fingers away from moving parts. Keep hoses and tools clear of moving parts. Always stay clear of moving engine
parts. Hoses and tools can be thrown through the air if not kept clear of moving engine parts.
• The unexpected movement of a vehicle can injure or kill. When working on vehicles always set the parking brake or block the wheels.
FUME HAZARDS
• FUMES, GASES, AND VAPORS CAN CAUSE DISCOMFORT, ILLNESS, AND DEATH! To reduce the risk of discomfort, illness, or death, read,
understand, and follow the following safety instructions. In addition, make certain that anyone that uses the equipment understands and follows
these safety instructions as well.