MAX SN890RH-R - Manual (Page 11)

11
e Release the pusher hook as pulling the pusher. Slide the pusher against the nails.
NOTE:
Be sure that tip of the pusher is located above the last nail’s head as shown.
TEST OPERATION
q Adjust the air pressure at 70 p.s.i. (5 bar) and connect the air supply.
w Without touching the trigger, depress the contact arm against the work-piece.
Pull the trigger. (The tool must fire the fastener.)
e With the tool off the work-piece, pull the trigger.
Then depress the contact arm against the work-piece.
(The tool must fire the fastener.)
r Adjust the air pressure as much as the lowest possible according to the diameters and length of
fastener and the hardness of work-piece.
Pusher hook
Pusher
Tip of the pusher
2
1
PROCEDURE
q Hold the trigger.
w Depress the contact arm.
DRIVING FASTENERS
CONTACT TRIP MODEL w/ANTI-DOUBLE FIRE MECHANISM
The anti-double fire mechanism (US patent 5597106, UK patent 2286790) is installed on this tool.
The common operating procedure on “Contact Trip” tools is for the operator to contact the work to
actuate the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work is
contacted. This will allow rapid fastener placement on many jobs, such as sheathing, decking and pallet
assembly. All pneumatic tools are subject to recoil when driving fasteners. The tool may bounce,
releasing the trip, and if unintentionally allowed to re-contact the work surface with the trigger still
actuated (finger still holding trigger pulled) an unwanted second fastener will be driven.
CONTACT FIRE OPERATION
For contact fire operation, hold the trigger and depress the contact arm against the work surface.