MAX RB397(CE) - Manual (Page 6)

7
7. NEVER OPERATE THE TOOL UNDER
ANY ABNORMAL CONDITION
If the tool is not in good working order, or if
any abnormal condition is noticed, switch it
off immediately (set the Main switch at OFF),
lock the Trigger and have it examined and
repaired.
8. AFTER BATTERY INSTALLATION IF THE
TOOL OPERATES WITHOUT THE TRIG-
GER BEING PULLED OR THE OPERA-
TOR NOTICES UNUSUAL HEAT, SMELL,
OR SOUND, DISCONTINUE OPERATION
Failure to do so may lead to serious injury.
Return to dealer for safety inspection.
9. NEVER MODIFY THE TOOL
Modifying the tool will impair performance and
operating safety. Any modification may lead to
serious injury and void the tool warranty.
10. MAINTAIN THE TOOL IN GOOD OPERAT-
ING CONDITION
To secure operating safety and ensure top
performance, keep the tool free of wear and
damage. Also keep the tool's hand grip dry
and clean, especially free of oil and grease.
11. USE ONLY THE AUTHORIZED BATTERY
PACK
Use only MAX JPL914 battery pack. If the
tool is connected to a power supply other
than the authorized pack, such as a re-
chargeable battery, a dry cell, or a storage
battery for use in automobiles, the tool may
be damaged, break down, overheat, or even
catch on fire. Do not connect this tool to any
power supply except the MAX JPL914 bat-
tery pack.
12. TO ENSURE MAXIMUM PERFORMANCE,
FULLY CHARGE THE BATTERY BEFORE
USE
A new battery pack or one not used for ex-
tended periods may have self-discharged
and thus may need recharging to restore it to
a fully charged condition. Before operating
the tool, make sure to charge the Battery
pack with the designated MAX Battery charg-
er JC928.
13. BATTERY CHARGING PRECAUTION
1 Use only MAX Battery charger JC928
and Battery Pack JPL914
Failure to do so may cause the Battery to
overheat or catch fire leading to serious
injury.
JPL914
JC928
JC928