AstroStart RS-611 User Manual
Page 7
5
CONFIRMATION
In all cases, your remote starter will confirm that a command has been received properly by flashing parking lights.
The horn provides certain confirmations when connected to system (requires optional wiring and material). In this manual,
confirmation signals are written in an abbreviated form; for example: (lights: 2) means that parking lights will flash twice.
THE START / STOP COMMAND
START / STOP (RS-611)
The Start-Stop command is in fact the reason for being of your remote starter. It allows you to start or stop your vehicle
without stepping outdoors. Press and hold the button down for at least two seconds.
U
PON STARTING
: The system automatically adjusts ignition duration for your type of vehicle; parking lights will flash once to
confirm the reception of the command, then will stay ON for as long as the engine is running under remote control.
U
PON STOPPING
: The engine and parking lights will turn off.
The command is only applicable when engine is running under remote control.
START (RS-613, RS-711XR)
To start the engine, press the
button (RS-613); (RS-711XR) (lights: 1).
The system automatically adjusts ignition duration for your type of vehicle; parking lights flash once then stay on all the time
engine is running.
Parking light confirmation is sent as many times as command is repeated so you are sure that system has received the
command. Horn sounds once if option "Confirmation on 2nd start” was set during installation.
STOP
When engine is kept running by Remote Starter, you can stop it by pressing and holding the:
RS-613 -
button for at least 4 seconds.
RS711XR - for at least 4-seconds.
Engine and parking lights will shut down.
This command also terminates panic mode.
I
F ENGINE FAILS TO START
If your system cannot start the engine at first attempt, it will wait for a few seconds and then try again. It could try again twice
depending on reason for failure to start.
After three attempts, it will shut down automatically and wait for a new command.
U
PON ENTERING YOUR VEHICLE
...
DO NOT TURN IGNITION KEY TO
START
POSITION
Automatic transmission vehicle
Manual transmission vehicle
To avoid turning the engine off when taking
place behind the steering wheel, do not apply
the brakes until you have placed the key in the
ignition and turned it to the RUN position.
Drive off as usual.
To avoid turning the engine off when taking place behind
the steering wheel, do not apply the brakes and do not
remove the parking brake until you have placed the key in
the ignition and turned it to the RUN position.
Drive off as usual.