Micromod Micro-DCI: 53ML5100A LOADING STATION - Manual (Page 24)

3.0 DISPLAYS AND PUSH BUTTONS
This section provides illustrations with item call-outs of the six operator displays and the engineer-
ing mode overlays. Where applicable, datapoints are identified parenthetically with the display
item call-outs. The datapoints are defined in Section 4. The front panel push button definitions are
repeated in this section from Section 1 because they are used in the engineering mode display
overlay examples to enter a key password, display a datapoint, and alter a datapoint. Hand Held
Configurer operating procedures, which are an alternative to datapoint entries via the front panel
push buttons, are described last in the section.
3.1 THE SIX OPERATOR DISPLAYS
Display 1 - Dual Channel Manual Loader (Chs. 1&2) is illustrated twice: in Figures 3-1 and 3-2 to
show channel 1 selected for output control and channel 2 selected for output control using the 3
push button. The remaining five operator displays are illustrated in Figures 3-3 through 3-7 as fol-
lows: Figure 3-3, Display 2 - Single Channel Manual Loader (Ch. 1 only); Figure 3-4, Display 3 -
Manual Loader with Analog Input (Ch. 1); Figure 3-5, Display 4 - Manual Loader with Analog Input
(Ch. 2); Figure 3-6, Display 5 - Analog Input Indicator with Setpoint Display (Ch. 1); and Figure 3-
7, Display 6 - Analog Input Indicator with Setpoint Display (Ch. 2).
Figure 3-1. Display 1 - Dual Channel Manual Loader (Chs. 1&2)
Showing Channel 1 Selected Using the 3 Push Button
ANO0 Tag Name (A244)
ANO0 Digital Readout
ANO0 Engineering Units
ANO0 Output Bar
ANO0 Scale Values
ANO1 Tag Name (A245)
ANO1 Digital Readout
ANO1 Engineering Units
ANO1 Output Bar
ANO1 Scale Values
Heavy Border Indicates
Active Window
CHANNEL 1
CHANNEL 2
3 Push Button
Section 3. Displays and Push Buttons
3-1