Milodon Windage Trays Ford, Chrysler, Pontiac, Olds Windage Tray Install - Manual (Page 2)

Special Considerations:
289-302 Ford – Initial install height from pan rail to lower tray adjusting nut – 3 1/8”, tray width
nearest block – 8”, uses a 4.950” long tray stud. Front sump mounts on #2 and 3
main caps. Rear sump mounts on #2 and 4 main caps.
351-W Ford – Initial install height from pan rail to lower tray adjusting nut – 3 5/8”, tray width
nearest block – 8 1/4”, uses a 5 ½” long tray stud. Front sump mounts on #2 and 3
main caps. Rear sump mounts on #2 and 4 main caps.
351-C Ford – Initial install height from pan rail to lower tray adjusting nut – 3 7/8”, tray width
nearest block – 8 1/2”, uses a 6” long tray stud. Front sump mounts on #2 and 3
main caps. Rear sump mounts on #2 and 4 main caps. Main stud threads in block
must be bottom tapped for proper pan to stud clearance. Maximum installed stud
height from pan rail to stud top must be 4 ½”.
429-460 Ford – Initial install height from pan rail to lower tray adjusting nut – 4” tray width
nearest block – 8 1/4”, uses a 6 ¼” long tray stud. Front sump mounts on #2 and 3
main caps. Rear sump mounts on #2 and 4 main caps In rear sump application
only, main stud threads in block must be bottom tapped for proper pan to stud
clearance. Rear sump maximum installed stud height from pan rail to stud top
must be 4 ½”. On all engines using high volume pumps that have a tang on the oil
pressure relief boss that interferes with the tray, you must cut this tang off to make
pressure relief boss more or less round in shape.
318, 340, 360 Chrysler – Initial install height from pan rail to lower tray adjusting nut – 4”, tray
width nearest block – 8 1/4”, uses a 6” long tray stud. Mounts on #3 and 4 main
caps.
Pontiac (All engines) – Initial install height from pan rail to lower tray adjusting nut – 4”, tray
width nearest block – 8”, uses a 6” long tray stud. Mounts on #2, 3 and 4 main
caps. Stock dipstick routing tube should be retained but will need to be securely
mounted.
Olds 455 – Initial install height from pan rail to lower tray adjusting nut – 4”, tray width nearest
block – 8 ½”, uses a 5 ¾” long tray stud. Mounts on #3 and 4 main caps. Main
stud threads in block must be bottom tapped for proper pan to stud clearance,
installed maximum stud height from pan rail to stud top must be 4 ½”.
5/00