Minuteman C8420-115_C8420-240 Ambassador 20 User Manual
Page 9
Parts and Instruction Manual
Page 6
1.
Filling: Fill the solution tank with the desired amount of water and add liquid cleaning
solution to the proper dilution ratio. DO NOT USE powdered cleaning chemicals.
Powders are unlikely to dissolve thoroughly, resulting in clogging the inline solution
filter. This can reduce or stop water flow to the pump and spray jets.
2.
Connect power supply cord to grounded wall outlet, Item # 4
3.
Engage traction drive system, Item #5
4.
Turn on main power switch, Item #2
5.
Lower scrub head assembly, Item #6
6.
Turn on pump switch to automatic, Item #12
7.
Turn on vacuum, Item #13
8.
Set forward/reverse switch to forward, Item #11
9.
Engage traction drive control levers, Item #14
10.
Adjust forward speed #3
11.
Brush pressure can be adjusted + or – by knob, Item #9, and viewing gauge, Item #10
in green zone
1.
Turn master switch off
2.
Disconnect vac hose, see item #8, and attach vacuum hose from remote tool.
3.
Disconnect solution hose, see item #7, and install remote tool solution hose to the
quick disconnect. Turn the pump solution switch, item #13, to auxiliary.
4.
Turn on main power switch.
5.
Turn on switch #13 to activate vacuum motor.
Accessory Attachments
Operating Instructions