ADC ISDN NT11010 - Manual (Page 24)

16
FCC compliance information
This device complies with part 15 of the FCC rules. Operation is subject to the fol-
lowing conditions: 1) This device may not cause harmful interference, and 2) this
device must accept any interference received, including interference that may cause
undesired operation.
Terminal S/T interface Supports point-to-point and multipoint
Conforms to ANSI T1.605, 1991-TX source
impedance, RX impedance, receive sensitivity
Line Four-wire, full duplex
Data rate 144 kbps available to customer
Line code AMI, 100% duty cycle
O/P amplitude 0.75V, zero-to-peak
Connector Two RJ45
DIP switches S/T interface termination
S/T bus timing mode
LED indicators Front panel power status lamp
S/T and U line error status lamp
U loopback status lamp
Mounting Options Standalone desktop or wall mount
Regulatory FCC part 15, Class B approval
UL 1459 approval
DOC CS03 approval
CUL CSA-235 approval
Table 6—Specifications
Parameter Specification